Turning Off The Power - Sony VPL-CS7 Operating Instructions Manual

on the room temperature or the screen
angle. In this case, adjust it manually.
Press the D KEYSTONE key on the
Remote Commander until "V Keystone"
appears on the screen, and adjust the
v
value with the /
corrected value is effective until the
power turn off.
• Be careful not to let the projector down
on your fingers.
• Do not push hard on the top of the
projector with the powered tilt adjuster
out. It may be occurred malfunction.
7
Turn the zoom ring to adjust the size
of the picture.
8
Turn the focus ring to adjust the focus.
Attention
Looking into the lens when projecting may
cause injury to your eyes.
V v B
/ / key. The
Turning Off the
Power
1
Press the I / key.
1
"POWER OFF? Please press I / 1 key
again." appears to confirm that you want
to turn off the power.
Note
A message disappears if you press any key
except the I / 1 key, or if you do not press
any key for five seconds.
2
Press the I / key again.
1
The powered tilt adjuster is put away in
the projector and the lens protector
closes. The ON/STANDBY indicator
flashes in green and the fan continues to
run for about 70 seconds (VPL-CS7)/for
about 90 seconds (VPL-ES2) to reduce
the internal heat. Also, the ON/
STANDBY indicator flashes quickly for
the first 60 seconds. During this time,
you will not be able to light up again the
ON/STANDBY indicator with the I / 1
key.
3
Unplug the AC power cord from the
wall outlet after the fan has stopped
running and the ON/STANDBY
indicator has light in red.
When you cannot confirm the on-
screen message
When you cannot confirm the on-screen
message in a certain condition, you can turn
off the power by holding the I / 1 key for
about two seconds.

Turning Off the Power

21