Connecting With A Monitor Equipment; Projecting - Sony VPL-CS7 Operating Instructions Manual

Connecting with a Monitor
Equipment (VPL-CS7 only)
This section describes how to connect the
projector to a monitor equipment.
For more information, refer to the
instruction manuals of the equipment you
are connecting.
Left side
AUDIO VIDEO S VIDEO INPUT A
MONITOR OUT
Monitor cable (not
supplied)
HD D-sub 15-pin (male)
↔ HD D-sub 15-pin
(male)
Monitor equipment
* This projector is not guaranteed for
connecting more than 2 monitors in loop-
through connection.
to monitor
input

Projecting

INPUT TILT
ON/STANDBY indicators
Remote control
detector
1
Plug the AC power cord into a wall
outlet, then connect all equipment.
The ON/STANDBY indicator lights in
red and the projector goes into standby
mode.
2
Press the I / key.
1
The ON/STANDBY indicator lights in
green and the Intelligent Auto-setup
starts. The lens protector opens, and the
powered tilt adjuster rises and stops at
the previously adjusted position.
3
Turn on the equipment connected to
the projector.
PUSH
MENU
ENTER
8
19
Projecting