Start-Up; Setting Up - Parkside PHD 150 F4 Translation Of The Original Instructions

• Use only extension cables that are pro-
tected from spray water and designed
for outdoor use. Always fully unroll a
cable drum before use. Check the ca-
ble for damage.
• Before any work on the equipment,
during work breaks and in the case
of non-use, remove the plug from the
socket.
• The cross-section of the power sup-
ply cable must not be less than
2 x 2,5 mm².
• Wear sturdy footwear to protect
against electric shock.
• To protect against electric shock, oper-
ate the equipment only in an upright
position.

Start-up

In keeping with current regulations a
pressure cleaner must never be oper-
ated off the drinking water mains
supply without a controllable back-
flow preventer. A suitable backflow
preventer in conformity with
EN 12729 type BA must be used.
Water that has passed through a backflow
preventer is classified as undrinkable.
A backflow preventer is available in spe-
cialist shops.
A system separator (check valve) prevents
the backflow of water and detergent into
the drinking water pipeline.
• Employ an ordinary garden hose for
the water intake and ensure sufficient
length.
• Use the device on a domestic water
connection with an output of at least
450 l/h.
• Irrespective of the water pipe, you can
also use the device (for example, rain
barrel) through the integrated water
suction function. This function must only
GB
be used with a suction hose with a fil-
ter basket.
The device itself must not be immer-
sed in open water sources. There
is a risk of personal injury from an
electric shock.
Do not draw in any water from na-
tural accumulations. There is a risk
of contamination from backwashed
cleaning agent.

Setting up

1. Pull the curved handle (1) up as far as
it will go.
2. Connect the high-pressure fitting (jet
gun) (28) to the jet gun (16). Ensure
that the hose runs to the front, so as not
to impede the handle (1).
3. Connect the feed hose to the water
supply and allow water to escape from
the other end of the feed hose with no
bubbles, in order to expel the air from
the feed hose. Switch off the water tap.
4. Connect the feed hose with the help of
the quick connector for garden hose
adapter (25) with the water connection
coupling (13) and the water connec-
tion (14) on the device.
5. Connect to the spray gun (16) by
inserting and screwing in the jet pipe
(20).
6. If the jet pipe (20) is mounted, connect
either the turbo dirt mill (24) or the
standard Vario nozzle (18) by screw-
ing in with the jet pipe (20).
7. Screw in to connect the detergent con-
tainer with nozzle (9) directly to the
spray gun (16). With using the clean-
ing agent container with the nozzle
(9), pour only cleaning agent into the
container. It is sucked in automatically.
The roles of the unit, use the handle
(1) only in conjunction with the
wheels (12). For lifting and carrying
use the carrying handle.
IE NI CY
9