Table of Contents
Advertisement
3.The engine should be run at idle speed for a
few minutes to allow sufficient warm-up time
to prevent engine damage before applying a
load. This will allow oil to reach engine parts,
and allow piston clearance to reach design
specification.
STOP
1.Release the throttle trigger back and run the
engine at the idling speed.
2. Turn the switch to the "OFF/STOP" position.
3. Suddenly stopping engine from high
speed operation can cause engine damage.
Reduce engine speed to idle speed for one
minute.
WARNING
Move the choke lever to the
unplug the spark plug if the engine can not be
shut down by the two upper steps,then adjust
the carburetor after the machine becomes
cold or contact the authorized dealer for help.
HANDLE ROTATION
The rear handle of the unit can be swiveled
to 5 different positions to suit the job
requirement.Including center position, 45°
position to the left and right,And 90°to the
left and right.This feature is particularly
useful for vertical and angled cutting.
1. Pull out the handle lock button;
2. Swivel the rear handle to the desired
position;
3. Release the button to lock the rear
handle securely in position.
45° 90°
WARNING
1.Do not swivel the rear handle when the
throttle lever is triggered.
2.When swiveling the rear handle, do not
trigger the throttle lever until the rear
position or
45° 90°
- 9-
handle is securely locked in position.Hedge
Trimmer must be stopped before adjusting
the swivel handle.
OPERATING
1.When cutting the hedges horizontally,
the unit should be held so that the blades
form 0-15° with the cutting direction.
2. At the vertical cutting, swing the blades up
and down on the hedges
WARNING
1. Always hold the unit firmly with both
hands.
2. When the throttle trigger is released, it
will take a little while before the blades
completely stop.
3. Use special caution when cutting hedges,
which are along with a wire fence.
The blades should not contact the fence,
otherwise the blades will be damaged.
4. The hedge trimmer is determined to cut
the hedges or small bushes.Do not use the
unit to cut thick branches, trees or grass,
which may damage the blades and
other parts.
5. If the blades are clogged by the leaves or
branches, immediately stop the
unit,and remove the stuff out of the blades.
0-15
Advertisement
Table of Contents
