Cub Cadet CC924HT Operator's Manual page 4

Before operation
Before operating the hedge trimmer, always ensure that the operating position is safe and secure.
Do not operate the hedge trimmer with a damaged or excessively worn blade.
Always ensure that all handles and guards are fitted when using the hedge trimmer. Never attempt
to use an incomplete hedge trimmer or one fitted with an unauthorized modication.
Check the machine for loose fasteners and fuel leakage. Make sure that the cutting device is properly
installed and securely fastened.
Inspect the hedge and work area to avoid damaging the cutting blades.
Make sure that the blades stop moving when the throttle lever is released and the engine runs at idle
speed.
Operation
Always use two hands to operate a hedge trimmer fitted with two handles.
Always be aware of your surroundings and stay alert for possible hazards of which you may not be
aware due to the noise of the hedge trimmer.
Do not put hands or feet near or under the moving blades while engine is running.
Keep any parts of your body away from the muffler when the engine is running.
Keep the cutting device below the waist level.
Do not cut too close to the ground in order to avoid hitting small stones.
Never touch the muffler spark plug, or other metallic parts while the engine is running or
immediately after shutting down the engine. It could cause serious burns or electrical shock.
To reduce re hazards, keep the engine and silencer free of debris, leaves and excessive lubricant.
Ensure that the hedge trimmer is correctly located in a designated working position before starting
the engine.
If the blades strike any foreign object or the hedge trimmer starts making any unusual noise or
vibration, immediately shut off the unit and allow it to stop. Check the unit for any damage and
repair the damage.
Stop the engine before
a. cleaning or when clearing a blockage
b. checking, carrying out maintenance or working on the hedge trimmer,
c. adjusting the working position of the cutting device,
d. leaving the hedge trimmer unattended.
Maintenance Storage and Transportation
When the hedge trimmer is stopped for servicing, inspection or storage, shut off the engine,
disconnect the spark plug wire and make sure all moving parts have come to a stop. Allow the hedge
trimmer to cool down before making any inspections, adjustments and etc.
Do not change the engine governor settings or overspeed the engine.
Replace faulty silencers and spark arrestors, if fitted.
Use only recommended, genuine replacement parts to avoid creating a hazard or voiding your
warranty.
Store the hedge trimmer where the fuel vapor will not reach an open flame or spark. Always allow
the hedge trimmer to cool down before storing.
When transporting or storing the hedge trimmer, always fit the cutting device transport guard.
-4-