Adjusting The Convergence Manually - Sony KDP-57WS655, KDP-51WS655 Operating Instructions Manual

Adjusting the Convergence Manually

z
For details on using the
Setup Menu, see page 94.
The Convergence feature gives you more control over the picture's
convergence than the Flash Focus feature, allowing you to fine-tune
the convergence.
✍
Before adjusting the convergence manually for the first time, you must first
perform Flash Focus (as described on page 44). Allow the TV to warm up for
about 30 minutes before you adjust the convergence.
1
Press to display the Menu.
MENU
2
Press V or v to highlight the Setup icon and press
3
Press V or v to highlight
A pattern of white crosses appears, with a yellow
of the crosses. Aligned crosses (which do not need adjustment)
look white and have little or no red or blue showing. Crosses that
are not aligned show red or blue shades beyond their edges.
Full/Normal
Move:
<
You can scroll up and down through the 9 x 7 field of crosses to
manually converge all portions of the screen.
4
Move the to surround a cross that you want to adjust. Press
. The changes to red.
5
If the cross that you selected has red edges, move until the red
image is replaced with a white cross. Once you have finished this
(or the cross does not have red edges), press
to blue.
6
If the cross you selected has blue edges, move until the blue
image is replaced with a white cross. Once you have finished this,
press . The
7
Repeat steps 4 to 6 to adjust other crosses. When finished, press
to exit the Setup Menu.
MENU
and press
Convergence
-
-
-
-
< End: Menu
Select:
changes to yellow again.
.
.
around one
. The changes
45