Adjusting The Convergence Manually - Sony KP-65WS510 Operating Instructions Manual

Installing and Connecting the Projection TV

Adjusting the Convergence Manually

z
For details on using the
Setup Menu, see page 60.
34
The Manual Convergence feature gives you more control over the TV's
picture than the Flash Focus feature, allowing you to fine-tune the color
alignment of each section of the TV screen.
✍
Before using Manual Convergence, you must first perform Flash Focus
(as described on page 33).
✍
Use the joystick of your remote control to perform the steps below.
1
Press MENU to display the Menu.
2
Move the joystick
3
Move the joystick to highlight Convergence and press
A pattern of white crosses appears, with a yellow
crosses. Aligned crosses (which do not need adjustment) look white and
have little or no red or blue showing. Crosses that are not aligned show
red or blue shades beyond their edges.
Full/Normal
Move
<
✍
You can scroll up and down through the 9 x 7 field of crosses to
manually converge all portions of the screen.
4
Using the joystick, move the
adjust. Press . The
5
If the cross that you selected has red edges, move the joystick until the
red image is replaced with a white cross. Once you have finished this (or
the cross does not have red edges), press
6
If the cross you selected has blue edges, move the joystick until the blue
image is replaced with a white cross. Once you have finished this, press
. The changes to yellow again.
7
Repeat steps 4 to 6 to adjust other crosses. When finished, press MENU
to exit the manual convergence screen and the Setup menu.
or to highlight the Setup icon and press
B b
- -
Select: End: menu
<
to surround a cross that you want to
changes to red.
.
.
around one of the
. The changes to blue.