Setting Up The Channel List; Using Initial Setup - Sony KDP-57WS655, KDP-51WS655 Operating Instructions Manual

Setting Up the Channel List

Using Initial Setup

z
If you are using a
CableCARD, Auto Program is
disabled for the CABLE input.
After you finish connecting the TV, you need to run the Initial Setup
feature, which automatically creates a list of available analog and
digital channels. The Initial Setup screens appear when you turn on
your TV for the first time after hooking it up.
To run Initial Setup
1
Press to turn on the TV.
POWER
The Initial Setup screen appears.
2
Using the remote control, move the highlight to the desired
language, then press
3
The next screen instructs you to connect your cable/antenna.
Check that you've connected your signal source correctly.
To start Auto Program, highlight
Auto Program automatically creates a list of receivable analog
and digital channels. Auto Program may take 50 minutes or more
to complete. A progress bar is displayed while the channel list is
being created.
The lowest numbered channel is displayed.
To run Auto Program again at a later time
❑
Use the Auto Program feature as described on page 89.
To add individual digital channels
Use the Digital Channel feature as described on page 89.
To reset the TV to factory settings
1
Press to turn on the TV.
POWER
2
Hold down on the remote control.
RESET
3
Press on the TV.
POWER
4
Release . (The TV will turn itself off, then back on.)
RESET
to select that language.
and then press
Yes
.
43