Adjusting The Table Top Height; Saving A Memory Position - LOGICDATA LOGIC OFFICE HSU Series Manual

7.1

ADJUSTING THE TABLE TOP HEIGHT

CAUTION Risk of minor or moderate injury through crushing
Your fingers may be crushed when you attempt to change the height of the table
• Keep fingers away from moving parts
• Ensure that no persons or objects are in the table's range of motion
INFO
The Table Top will move up or down until the UP or DOWN Key is released, or if a pre-de-
fined stopping point has been reached.
To move the Table Top UP:
Press and hold the UP Key until the desired height has been reached
To move the Table Top DOWN:
Press and hold the DOWN Key until the desired height has been reached

7.2 SAVING A MEMORY POSITION

This function saves a set Table Top position. One Memory Position can be saved per Memory Position Key.
1. Move the table to the desired height
7 3
▸ The display shows the Table Top height (e.g. 73 cm)
SAVE
2. Press the SAVE Key.
2
3. Press the Memory Position Key (e.g. 2)
s 2
▸ The display shows S 2
7 3
▸ After about two seconds, the Table Top height is displayed again
HSU - MANUAL // PAGE 15