EMS 53-5414 Installation And Programming Instructions page 9

EMS 5000 FIREPOINT
22 Press the "YES" button and the screen will display:
23 Once completed the screen will display:
24 Push any key and the screen will display:
25 Press the "" key, until 'the screen displays:
26 Push any key and the screen will display:
The above display can be used to check how many remote receivers are communicating
with the Control Panel. For each remote receiver that is connected, the MAS number
shown will increase by 10. I.e. if one is connected the MAS will show MAS010 if two
receivers are connected the MAS will show MAS020.
27 Press the "No" key twice. The screen will change to display:
28 Press the "" key, until 'the screen displays:
29 Press the "YES" button and the screen will display:
30 Press the "" key, until 'the screen displays:
31 Press the "YES" button and the screen will display:
32 The collector should be set to "ENABLED", press the "YES"
key to change its status. Once set to "Enabled" press the
"NO" key. The screen will display:
©2015 EMS Security Group Ltd. All rights reserved.
9
Re-initialising Bus
Please wait....* *
Push any key TIME
Re-initialising Bus
Please wait....*Done*
Push any key TIME
| Device Table
>Re-start Bus <
| Re-Online Device |
YES = Select TIME
| Printer Redirect
>Monitor Comms <
| Delete Device |
YES = Select TIME
HEAP00 AUX=00 PGR=00
REM000 MAS010 T00-00
I00 L00 R00 S00 C00
Push any Key TIME
| System Support |
> Serial Comms <
| Pager Setup
Yes= Select Time
| Logging |
>Remote Rxers <
| Ext. Comms |
Yes= Select Time
|* Remote Receivers *|
>Receivers Found <
| Enable Receiver |
Yes= Select Time
| Enable Receiver |
>Enable Collector <
| Monitor Traffic |
Yes= Select Time
Collector: ENABLED
Push Yes to change
Push No to escape
Yes= Select Time
| Enable Receiver |
>Enable Collector <
| Monitor Traffic |
Yes= Select Time
TSD244 Iss 3 25/06/15 AJM
|
|
|