Tools & Test Equipment; Receiver Position; Uhf Remote Receiver Relevant High Gain Aerials - EMS 53-5414 Installation And Programming Instructions

EMS 5000 FIREPOINT
UHF Data
Transmitting
Aerial
2. Tools & Test Equipment
Only standard hand tools are required to install the Remote radio receiver system. No
special test equipment is needed when installing the receiver, although signals from
devices can be seen if a computer with a terminal programme is connected to the
system.
This gives a visual indication that the remote receivers are passing device data to the
main control panel.

3. Receiver Position

The maximum range between remote receiver and any device is dependant upon the
environment in which the system is operating. The actual range achieved is determined
by local site conditions. For range improvements high gain aerials can be attached to the
remote receivers. The table below indicates relevant aerials:-

4. UHF Remote Receiver Relevant high gain aerials

5-5501/High gain aerial c/w 3 metres of cable and bracket.
5-5501/BP10/High gain aerial c/w 10 metres of cable, wall mounting bracket and
extension pole.
5-5501/BP20/High gain aerial c/w 20 metres of low loss cable, wall mounting bracket
and extension pole.
5-5501/BP30/High gain aerial c/w 30 metres of low loss cable, wall mounting bracket
and extension pole.
©2015 EMS Security Group Ltd. All rights reserved.
VHF Data
Receiving
Aerial
VHF Remote Radio
Receiver
Figure 2
4
Fire Detection Device
Transmissions (i.e.
Call points/ Smoke &
Heat Detectors/
Sounders).
VHF Data
Receiving
Aerial
TSD244 Iss 3 25/06/15 AJM