Table of Contents
Advertisement
EMS 5000 FIREPOINT
9. Testing The System
If the system is not performing as expected in terms of range, monitoring the Comms
between the main and remote receivers may well indicate the cause of the problem (see
Figure 3).
For example, a large number of Time-outs by a particular remote indicates a poor
connection, poor screening, or the cable passing near enough to a data cable to
introduce interference onto the bus.
Once VHF Remote units have been installed and are communicating with the Control
Panel, devices should now be tested from their fixed positions.
Once UHF Remote units have been installed and are communicating with the Control
Panel, the transponder units which will send device information to the remote receiver
should be installed (see transponder installation instructions for details).
©2015 EMS Security Group Ltd. All rights reserved.
TSD244 Iss 3 25/06/15 AJM
12
Advertisement
Table of Contents
