EMS 53-5414 Installation And Programming Instructions page 10

EMS 5000 FIREPOINT
33 Press the "NO" key once and the screen will display:
34 Press the "" key, until 'the screen displays:
35 Press the "YES" button and the screen will display:
36 Press the "YES" button and the screen will display:
37 Enter "00" followed by the "YES" key. The screen
will display:
38 Push any key and the screen will display:
39 Press the "" key, until 'the screen displays:
40 Press the "YES" button and the screen will display:
41 The router should be set to "ENABLED", press the "YES"
key to change its status. Once set to "Enabled" press the
"NO" key. The screen will display:
42 Press the "NO" key twice and the screen will display:
43 Now turn the control keyswitch to the "OFF" position and
the screen will display: The Remote Receiver is now
programmed to the System.
©2015 EMS Security Group Ltd. All rights reserved.
10
| Logging |
>Remote Rxers <
| Ext. Comms |
Yes= Select Time
| Checksum Data |
> Network Router <
| Radio Lan |
Yes= Select Time
| * *|
NETWORK ROUTER
>Setup local NUA <
| View network NUA
Yes= Select Time
Local NUA :
Input Local NUA_
Yes= Finish Time
_ _SET AS MASTER _ _
Push Any Key Time
| * *|
NETWORK ROUTER
> Setup local NUA <
| View network NUA |
Yes= Select Time
| Network Name |
> Control Routing <
| Send Test
Yes= Select Time
Routing : DISABLED
Push YES to change
Push NO to escape
Yes/No Time
| Network Name |
> Control Routing <
| Send Test |
Yes= Select Time
Panel In Access
Date Time
Status Normal
Date Time
TSD244 Iss 3 25/06/15 AJM
|
|