Programming The Remote Control - Sony GRAND WEGA 2-059-370-14(2) Operating Instructions Manual

Using the Remote Control

Programming the Remote Control

62
The remote control is preset to operate Sony brand video equipment.
Sony Equipment
DVD/VCR
SAT/CABLE
If you have video equipment other than Sony brand that you want to control
with the LCD projection TV's remote control, use the following procedure
to program the remote control.
✍
The equipment must have infrared (IR) remote capability in order to be
used with the remote control.
From the "Manufacturer's Codes" listed on page 63, select the three-digit
code number for the manufacture's code of your equipment. If more than
one code number is listed, try entering them one by one until you come to
the correct code for your equipment. Use the code number to complete the
following procedure.
1
Press the DVD/VCR (FUNCTION) and RESET buttons
simultaneously, or press the SAT/CABLE (FUNCTION) and RESET
buttons simultaneously. DVD/VCR and SAT/CABLE buttons flash.
2
Press the function button you want to program.
To program a cable box or a satellite receiver
Press SAT/CABLE (FUNCTION).
To program video equipment
Press DVD/VCR (FUNCTION).
3
Enter the three-digit manufacturer's code number using the 0 - 9
buttons.
4
Press ENT (enter) button.
✍
If no code number is input within 10 seconds, or an invalid or incorrect
code number is input, the remote control automatically goes back to the
previous setting.
5
To check if the code number works, aim the TV's remote control at the
equipment and press DVD/VCR and/or SAT/CABLE (POWER) that
corresponds with that equipment. If it responds, the programming is
completed. If not, try using the other codes listed for that manufacturer.
✍
In some cases, you may not be able to operate your equipment with the
supplied remote control. In such cases, use the equipment's own remote
control unit.
Programmable Code Number
601 (Sony Dream System)
801 (Sony Satellite Receiver)