Connections - Sony UP-D77MD Instructions For Use Manual

Connections

Connect the unit to the 100BASE-TX LAN.
Notes
• Connect the AC power cord last.
• Before connecting to the LAN, be sure to set up the
required IP address and sub-net mask.
For detailed information, refer to "Setup Manual"
provided in the latter part of this manual, and also
consult the system administrator.
• Before connecting the unit using a 100BASE-TX
cable, attach the ferrite cores provided to both ends of
the cable for noise prevention.
For detailed information on how to attach the ferrite
cores, see "How to attach the ferrite cores" on page 8.
to the network connector
100BASE-TX cable
to the LAN
a) Be sure to use a network cable of less
than 30 m in length, and rated more than
category 5.
How to attach the ferrite cores
Before using the unit, attach the supplied ferrite cores
for noise prevention.
To confirm to radiation standards, attach the supplied
ferrite cores to both ends of the cable.
8
Connections
to- AC IN
a)
Power cord
Ferrite core
Stoppers
About 13 mm
(1/2 inch)
1
Release the two stoppers to open the ferrite core.
2
Make a loop at the end of the cable about 13 mm (1/
2 inch) away from the connector, and then attach
the ferrite cores.
3
Close the ferrite core until it clicks.
About 13 mm
(1/2 inch)