Checking The Accessories; Connections - Sony UP-D711MD Instructions For Use Manual

Checking the
accessories
Check the accessories.
Thermal head cleaning sheet (1)
Before Using this Printer (1)
CD-ROM (1)
Service Contact List (1)
European Representative (1)

Connections

With the DC cable disconnected from the external power
supply, connect the USB connecting cable between the
unit and computer, then connect the DC cable. For
details about the unit connection, refer to the manuals
for the computer or other peripheral devices.
WARNING
Using this unit for medical purposes
The connectors on this unit are not isolated.
Do not connect any device other than one which
conforms to IEC 60601-1 standards.
When an information technology device or AV device
that uses an alternating current is connected, current
leakage may result in an electric shock to the patient or
operator.
If use of such a device is unavoidable, isolate its power
supply by connecting an isolation transformer, or by
connecting an isolator between the connecting cables.
After implementing these measures, confirm that the
reduced risk now conforms to IEC 60601-1 standards.
Notes
• Make sure that the USB cable is connected securely at
both ends.
• Make sure that the DC cable is connected securely
until it is locked.
• The unit drive software provided with the unit is not
suitable for using the unit connected to a network.
• Printer operation is not guaranteed when connecting
to the computer using the USB cable via a USB hub.
• Use a DC 12 V – DC 24 V power supply with at least
72 W, for the unit.
(DC12V 6A or greater, DC24V 3A or greater)
• Before connecting or disconnecting the DC cable, be
sure to turn the external power supply off. Otherwise
damage to the unit may result.
11