Loading The Paper - Sony UP-D77MD Instructions For Use Manual

Dicom color printer
Table of Contents

Advertisement

4
Load the ink ribbon to ink ribbon holder.
1 Load the spool holding the ink ribbon into the right-hand
part of the holder, while pressing in the arrow direction.
Ink ribbon holder
(supplied)
2 Fit the other
spool into the
Bar code
left-hand part of
the holder.
5
Remove any slack from the ink ribbon.
If the ribbon is left slack, it may be crumpled and
damaged when inserted.
“Start” position
marker
Wind the spool until the
“Start” position marker faces
upward.
6
Insert the ink ribbon cassette firmly until it stops.
SONY mark faces forwards.
7
Close the ribbon door.
Before Printing
If your ink ribbon should tear
Repair the tear with transparent tape. There should be no
problem with using the remaining portion of the ribbon.
Transparent
tape
Remove any
slack.
Notes When storing ink ribbons
• Avoid placing the ink ribbon in a location subject to:
– high temperatures
– high humidity
– excessive dust
– direct sunlight
• Store partially used ink ribbon in its original package.

Loading the Paper

Load the paper by the following procedure. Be careful
not to touch the printing surface of the paper.
Note
When loading the paper, do not turn off the power. If you
turn off the power, the image data stored in the memory
will be lost.
1
Press PUSH on the paper tray.
The paper tray is ejected.
Remove the printing surface
protection sheet, if any.
Paper tray
2
Open the tray cover and place the paper in the paper
tray.
Page 10

Advertisement

Table of Contents
loading

Table of Contents