Maintenance - Graco GrindLazer Pro RC813 G Operation, Repair, And Parts

Maintenance

Avoid touching engine and cutter head after use until
they have completely cooled. To avoid injury from
unexpected start up, disconnect spark plug wire and
black battery cable before you service your unit.
The following steps should be performed to maintain
proper operation and sustain the life of the GrindLazer.
BEFORE OPERATION:
• Visually inspect the entire unit for damage or loose
connections.
• Check engine oil (see engine manual).
• Check bushings and cutters.
• Check cutter for uneven wear.
DAILY:
• Check all fasteners and re-tighten.
• Clean dust and debris from exterior of unit (do NOT
use pressure washer or other high pressure
cleaning equipment).
• Inspect dust skirts for damage. Repair or replace
damaged skirts in order to help dust and debris
containment.
• Check engine oil level and fill as necessary.
• Check and fill gas tank.
• Remove air filter cover and clean element. Replace
element if necessary. Replacement elements can
be purchased from your local engine dealer.
• Grease the Cutter Head Engage Lever and lower
linkage (non-DCS models only).
3A5581C
AFTER THE FIRST 20 HOURS OF
OPERATION:
• Drain engine oil and refill with clean oil. See engine
manual for correct viscosity.
EVERY 40-50 HOURS OF OPERATION:
• Change engine oil (see engine manual).
• Grease wheel bearings.
AS REQUIRED:
• Check drive belt and tension and tighten or replace
as needed.
For additional information about engine maintenance,
see engine manual.
Maintenance
23