Operation; Machine Start Up - Graco GrindLazer Pro RC813 G Operation, Repair, And Parts

Operation

Operation
Do not start machine while cutter head is in contact
with the ground. Doing so can cause the operator to
lose control of the machine, resulting in property
damage and/or personal injury.

Machine Start Up

Before starting engine, perform the following:
• Read and understand engine manual.
• Make sure all guards are in place and secure.
• Make sure all mechanical fasteners are secure.
• Inspect for damage to engine and other exterior
surfaces.
• Inspect work area to locate any pipes, columns,
deck inserts, or other objects protruding from work
surface. Avoid these objects during operation.
Starting the Engine
• Connect Engine Kill Button Cord to operator and
machine.
16
• Open the fuel shut off on the gas tank and then
place the throttle lever at the "fast idle" position.
• Move the choke to closed.
• Push the Electric Start Engine Switch to start the
engine.
• After the engine starts, move choke to open.
• Set throttle to desired setting.
If the Engine Does Not Start
• Check engine for proper gas level.
• Check the spark plug. Make sure socket areas are
clean and clear of debris, and the proper gap is set.
Replace if needed.
• Battery might be dead. Try pulling the starter cord.
• Engine may have tilted backwards. If so, allow oil to
drain after removing spark plug.
• If engine still does not start, refer to the engine
manual.
• The engine will not start without the Corded Engine
Kill Clip securely in place.
3A5581C