Repair
Repair
Belt Replacement and
Adjustment
To avoid injury from unexpected start up, disconnect
spark plug wire and black battery cable before you
service your unit.
1. Remove Clevis Pin.
2. Non-DCS Models: Rotate Cutter Head Engage
Lever to upwards position to release lower linkage
from inner frame.
DCS Models: Press Home Button on the DCS Control.
26
3. Use the Pressure Control Dial to set the Pressure
Indicator to 0. This releases tension from the
pressure control spring.
Max
Min
4. Unhook spring from the spring plunger (bottom rear
section of machine).
3A5581C