Dcs Instructions - Graco GrindLazer Pro RC813 G Operation, Repair, And Parts

DCS Instructions

Each time the DCS Control is turned on, the DCS actua-
tor will travel to the Home position.
Once the DCS Control finds Home, ensure the correct
model is selected as well as your desired language and
units. See Menu Screens, page 14, for instructions on
changing these settings.
Set Zero Point:
With the engine on, lower the cutter head by pressing
the Down Arrow Button until you hear the cutters make
contact with the pavement surface. Hold down the Zero
Button for 2 seconds. Your Zero Point has now been
saved.
NOTE: The Cut Depth Target is based off of the Zero
Point. Re-program the Zero Point if the cutter head is
changed or worn.
3A5581C
Set Cut Depth Target:
Quick press the Zero Button to take the cutter head to
the pavement surface. Set the Cut Depth Target by:
1. Quick pressing the Down Arrow Button as many
times as needed to achieve your target. Then long
press the Cut Depth Button to save your target.
NOTE: This method will lower the cutter head into
the pavement surface as you set your cut depth.
OR
2. From the Zero Point, long press the Cut Depth But-
ton until a new screen pops up. Use the Down
Arrow Button to enter your Cut Depth Target. Then
long press the Cut Depth Button to save your target
and return to the Run Screen.
NOTE: This method will keep the cutter head sta-
tionary as you set your Cut Depth Target.
Operation
21