Table of Contents
Advertisement
Maintenance
Tools Required
The following tools are required to perform regular main-
tenance on the gun.
•
7/16 in. wrench
•
1/2 in. wrench
•
9/16 in. wrench
•
5/8 in. wrench
•
11/16 in. wrench
•
3/4 in. wrench
•
13/16 in. wrench
•
5/64 in. allen key
•
3/32 in. allen key (supplied)
•
9/64 in. allen key (supplied)
•
3/16 in. allen key (supplied with cutter assembly)
•
1/2 in. deep well socket
•
9/32 in. socket
•
7/32 in. deep well socket
Task
Add Oil to Air Motor,
page 9
Replace Anvil, page 10
Replace Blade Car-
tridge, page 11
332574A
Schedule
3-4 drops per 8 hours of
use
When surface is badly
scored or does not cut
When glass roving is no
longer cut cleanly (verify
proper tension first)
Air Motor Oiling
1. Perform Pressure Relief Procedure found within
the RS Gun and Cutter, Operation-Repair manual.
2. Engage trigger lock.
3. Rotate speed control until oil mark line is aligned
with line on back plate of the cutter.
4. Add 3-4 drops of air motor oil, Graco part 202659,
into oil hole on air motor.
Maintenance
ti21010a
ti21001a
9
Advertisement
Table of Contents
