Bosch Rexroth Marex SB Manual page 42

Error type: CTRL-POS
1
2
Error description: Before adjusting parameters for speed and gear control, the active
3
control head must be placed in the correct position (see chapter 4.3 or 4.4). It is not
4
permitted to adjust the parameter in this lever position.
Error elimination: Change to RUN-mode (step 1 in chapter 4.3 or 4.4). Move lever in
correct position then and repeat the adjustment.
Error type: PROCEDURE
1
2
Error description: Parameters were set (chapter 4) in incorrect order (e. g. adjustment of
3
rotary switch PARSEL in SETUP-mode).
4
Error elimination: Change to RUN-mode (step 1 in chapter 4.3 or 4.4). Move lever in
correct position then and repeat the adjustment.
Error type: ADJUST
1
2
Error description: It has been tried to set a parameter (chapter 4) that does not exist at all
3
according to the system configuration (chapter 2) (e. g. rpm starboard for a single engine
4
system). Or, the rotary switch PARASEL was turned to a value which was not admissible.
Error elimination: Correct setting of switches and rotary switch PARSEL.
39