Bosch Rexroth Marex SB Manual page 11

Entering the identification (ID)
To enable the control to identify the control heads, an individual ID must be
entered once at every control head (e. g. control head bridge ID 1, control head
!
port ID 2, control head starboard ID 3)
ID 0 is not admissible.
à This procedure is not necessary, if the automatic ID setting is used. (Chapter
4.2)
To enter the ID, the housing cover must be removed.
bottom side control head
starboard side
X1
adjustment
7
ID (1...6)
6
5
4
3
LED power supply
2
1
LEDcommunication ok
port side
8
Adjustment
ID (1...6)
!
On every control head, an individual
once.
ID must be entered
ID 0 is not admissible.
ok