Bosch Rexroth Marex SB Manual page 24

Procedure for automatic ID-setting
Step Action
1 Activate control.
2 Hold down switch S1.
3 Shift CTRHEAD switch 1 to close.
4 Do not further operate switch S1.
5 The control head buzzers sound at short intervals.
In addition, the control head LEDs are active (see step
6) and flash in the same frequency as the buzzer.
6 Press the keys of the control heads one after another.
7 Signals after one keystroke:
The buzzer stops.
The ID which was stored is indicated by the LEDs of
the control head.
The LEDs flash slowly.
21
Diagram
key
switch S1
1
CTRHEAD
1
2
3
4
switch S1
COMMAND
ALARM
SYNCHRO
COMMAND
ALARM
SYNCHRO