Operation - Ecowood Pretty Installation, Users And Maintenance Handdook

Pretty - Nice - LADy
UK
between the stove and the floor, if the latter could be inflammable, be sure to insert heat
protection, ensuring it protrudes at the front and sides by at least 20 cm.
connect the power supply cable to a 230 volt mains outlet.
make sure that the body work of the stove is earthed correctly.
NOTE: it is possible to change the direc-
tion of the flue gas outlet, (standard, on
the back inside the stove) so that the
outlet can be on the left side, looking at
the stove from the front. To take advan-
tage of this possibility it is necessary to
disassemble and turn the flue exhauster
motor screw through 90°, tighten the
screws in the new position and make an
90 mm hole on the desired side.
This modification must be done only and exclusively by the installer.
Is not possible to change the direction of the flue gas outlet on the stove with majolica
covering (NICE CER)

opEration

• After installing the stove as described above, fill the tank on top of the stove with the
pellets through the door on the stove. the tank should always contain enough fuel to
guarantee a regular supply to the stove and the door should be closed during operation.
• make sure that the crucible is correctly inserted into the tray.
if the crucible is not inserted properly or is very dirty it may cause poor combustion
or the fire may not ignite.
• make sure that the hearth door and the ash collection drawer are closed properly so
that smoke does not escape, moreover, excessive air infiltration will increase smoke
production and deposit more dirt in the hearth and on the glass.
• During the ignition stage (25 minutes), the pellet loading rate is that setted by the manufac-
turer and cannot be changed.
8