Table of Contents
Advertisement
2. if the stove goes out during operation:
• check all the possibilities in previous section.
• check whether the stove is ready for programmed cleaning after 2500 hours have ex-
pired. the display will show cleaning/maintenance message.
• make sure that the thermal safety switch (re-settable manually), on the inside back right
of the stove, has been reset.
remark: on all LADy models the switch is located underneath the stove left-hand side.
• before resetting the switch find the reason for its triggering.
Note that the thermal switch can only be reset with electrical supply off and when the stove
temperature has fallen below 93°C.
poWEr FaiLurE
Brief power failure: if there is a brief power failure (60 seconds), when the stove is at the
ignition stage or is operating normally, the stove is programmed to re-ignite itself. if the
power failure lasts for a longer, indefinite period, when the power returns the stove will go
into an extinguishing cycle, setting up for the next (manual or programmed) ignition. in this
case the display will show Black-out message.
to reset the stove functions, switch it ON-OFF.
temporary power failure: if there is a power failure lasting 3÷5 minutes, with direct flue
gas exhaust pipes the stove may emit some smoke into the room, produced by the unburnt
pellets present in the grate.
this does not constitute a safety risk. the problem can be avoided by installing the exhaust
pipe as shown on this handbook.
Electrical safety: the stove is protected against power surges by two fuses on the elec-
tronics board.
Pretty - Nice - LADy
13
Advertisement
Table of Contents
