Table of Contents
Advertisement
• the hot air fan comes on automatically about 15 minutes after ignition, at the first
speed, and levels itself at the selected power for the normal operating cycle, 25 minutes
after ignition.
• it is possible to adjust the hot air fan separately from fuel loading rate (only for the first
two power levels); the two functions are currently set proportionately by the manu-
facturer.
• to switch off the stove completely just press the ON/OFF button again; after the flame
has gone out the stove will remain in operation for about 25 minutes until all the inter-
nal parts have cooled down.
important
Continuous operation of the stove at maximum power could shorten the life of the electronic and
mechanical components, and also reduce safety.
The stove is able to operate continuously for long periods of 10÷15 hours if the selected pellet
loading power level does not exceed the third position.
Using the stove at the fourth or fifth loading rate for long periods will reduce safety, therefore an
automatic power limiting device has been installed as standard in the stove.
if the automatic power limiting device is disabled at the user's request (this should be done
by the installer technician following an evaluation of the conditions under which the stove
is to be used), it is necessary to connect the stove to the flue gas exhaust system using
stainless steel pipes, or pipes painted with airtight seals. if the fourth power level is se-
lected we advise operating the stove continuously at this level only if it is alternated
hourly with operation at lower load rates, while the fifth level should only be used con-
tinuously for a maximum of 30 minutes.
rEar air discHargE Function
(LADy model excluded)
to use rear air discharge, take into account the following
recommendations:
When the stove is used with a closed butterfly valve, the
power selector should not be set higher than third
speed to avoid overheating, causing the heat safety switch
to activate. the switch can be found to the right, at the rear
inside the stove.
if this happens, the user must wait until the stove cools
down to a temperature less than 93°c so as to be able to
reactivate and ignite the stove again.
Pretty - Nice - LADy
9
Advertisement
Table of Contents
