Prlk396A0 Wiring - LG PAHCMS000 Installation Manual

EEV KIT INSTALLATION

PRLK396A0 Wiring

Wiring Installation
1. Open the terminal box cover.
2. For PRLK396A0 / PRLK594A0, run the field-supplied wiring (six [6] wired, 18AWG, stranded, shielded copper) to / from the AHU Commu-
nications Kit through the cable connector on the EEV Kit.
3. Connect wiring to the terminal connections following the label and color codes pasted onto the bottom of the terminal box and shown
below. Securely tighten all connections.
4. Route the wiring through and out the EEV Kit as shown, and secure with the support tie (D).
5. Re-install the terminal box cover and secure the cover with the four (4) screws.
6. Taking care not to damage the field-supplied wiring or insulation, reattach the EEV Kit Top Panel by securing it with the screws at the four
(4) corners.
Figure 26: PRLK396A0 EEV Kit Wiring.
Field Wiring
BR : Brown OR : Orange
RD : Red YL : Yellow
BL : Blue WH : White
Figure 27: PRLK594A0 EEV Kit Wiring.
Field Wiring
BR : Brown OR : Orange
RD : Red YL : Yellow
BL : Blue WH : White
52
Detail
D
Pipe Outlet 5/8
to AHU coil liquid
pipe connection
Detail
C
D
BR: Brown
RD: Red
BL: Blue
OR: Orange
YL: Yellow
WH: White
A. Terminal Box Cover
B. Cable Strain Relief Connector
C. Terminal Connector
D. Electrical Wiring (field supplied,
6 wires, 18 AWG, stranded,
shielded
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
PRLK396A0 EEV Kit
(cover removed)
7-1/2
A
B
Mounting
Hole 1/4
PRLK594A0 EEV Kit
(cover removed)
9-7/8
Pipe Outlet 5/8 Pipe Inlet 5/8
to AHU coil liquid from ODU
pipe connection
AHU controller
D
A. Terminal Box Cover
B. Cable Strain Relief Connector
C. Terminal Connector
D. Electrical Wiring (field supplied,
6 wires, 18 AWG, stranded,
Pipe Inlet 5/8
shielded
from ODU
AHU controller
A
D
B
AHU EEV controller
D
(sold separately)
Mounting
Hole 1/4"
scale : inch