Prlk048A0 And Prlk096A0 Wiring - LG PAHCMS000 Installation Manual

Wiring Installation
1. Open the terminal box cover (A) by unscrewing the four (4) M4 screws.
2. Run field-supplied wiring (six [6] wired, 18AWG, stranded, shielded copper) to / from the AHU Communications Kit through the cable
connector on the EEV Kit.
3. Connect wiring to the terminal connections as shown (C), following the label and color codes pasted onto the bottom of the terminal box
and listed on the AHU Communications Kit PCB diagram. Securely tighten all connections.
4. Route the wiring through and out the EEV Kit as shown, and secure with the support tie (D).
5. Re-install the terminal box cover (A) and secure with the four (4) M4 screws.
6. Taking care not to damage the field-supplied wiring or insulation, reattach EEV Kit top panel by securing with screws at four (4) corners.
Figure 25: PRLK048A0 and PRLK096A0 EEV Kit Wiring.
EEV Kit
(Top Cover Removed)
7-1/2"
13-5/16"
Pipe Outlet 1/2"
to AHU coil liquid
pipe connection
Before connecting the field-supplied wiring, compare with the connection labels between EEV Kit and AHU Communications Kit. Connect the
wiring according to the PCB diagram for the AHU Communications Kit� If the wiring is incorrect, the products will malfunction�
Mounting
Hole 1/4"
A
B
D
E
Pipe To AHU
Inlet 1/2" Communications
from ODU Kit
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
EEV KIT INSTALLATION

PRLK048A0 and PRLK096A0 Wiring

Detailed View
B R
R D
F
A . Terminal Box Cover
B . Cable Connector
C. Terminal Connections
D. Support Tie
E. Field-Supplied Wiring (Six [6] Wires, 18 AWG,
Stranded, Shielded)
F: Terminal Connection Label
C
EEV
BR: Brown
B O Y W
L R L H
RD: Red
BL: Blue
OR: Orange
YL: Yellow
WH: White
E
51