Testing - LG PAHCMS000 Installation Manual

Testing

Before testing, make sure all information is understood completely, and follow the guidelines listed in this manual.
• Check the air-source / water-source unit refrigerant piping, additional refrigerant charge, maximum allowable piping length, and opening the
shut-off valve. (For more detailed information, see the respective air-source / water-source unit installation manual).
• Operate the testing procedure.
1. Connect the power, and turn the system on.
2. Check remote controller for error codes.
Figure 28: Wired Remote Controller Buttons.
1
10
9
8
7
11
12
13
14
15
16
17
• For more detailed function of the wired remote controller, refer to its Owner's / Installation Manual.
• Buttons 3, 4, 11, 12 on the wired remote controller do not operate�
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
1. Operation indication screen
2. Set temperature button
3. Fan Speed button
4. Set back button
5. Operation mode selection button
6. Wireless receiver - some equipment are not
equipped to receive the wireless signals
7. Sub-function button
8. Ventilation button
2
9. Reservation button
3
10. Air flow button
11. Cooling desired temperature
4
12. Function setting button
13. Up, Down, Left, Right button
14. On/Off button
5
15. Heating desired temperature
16. Setting/Cancel button
6
17. Exit button
TESTING
57