Fixture Linking (Master/Slave Mode); Mounting/Rigging - Blizzard Lighting PROPAR COB RGBAW Manual

Fixture Linking (Master/Slave Mode)

1. Connect the (male) 3/5-pin connector side of the DMX cable to the output
(female) 3/5-pin connector of the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a
(female) 3/5-pin connector to the input connector of the next fixture consist-
ing of a (male) 3/5-pin connector. Then, proceed to connect from the output as
stated above to the input of the following fixture and so on.
Check the "Operating Adjustments" section in this manual for complete in-
structions for this type of setup and configuration.
Mounting & Rigging
This fixture may be mounted in any SAFE position provided there is enough
room for ventilation.
It is important never to obstruct the fan or vents pathway. Mount the fixture
using a suitable "C" or "O" type clamp. The clamp should be rated to hold at
least 10x the fixture's weight to ensure structural stability. Do not mount to
surfaces with unknown strength, and ensure properly "rated" rigging is used
when mounting fixtures overhead.
Adjust the angle of the fixture by loosening both knobs and tilting the fixture.
After finding the desired position, retighten both knobs.
• When selecting installation location, take into consideration lamp replace-
ment access (if applicable) and routine maintenance.
• Safety cables MUST ALWAYS be used.
• Never mount in places where the fixture will be exposed to rain, high humid-
ity, extreme temperature changes or restricted ventilation.
ProPar COB RGBAW Manual - Rev. B
A quick note: Often, the
setup for Master-Slave and
Standalone operation re-
quires that the first fixture
in the chain be initialized
for this purpose via either
settings in the control panel
or DIP-switches. Second-
arily, the fixtures that follow
may also require a slave
setting.
Page 9
(c) 2019 Blizzard Lighting, LLC