Fixture Linking (Master/Slave Mode); Clamp Mounting; Securing The Fixture - Blizzard Lighting Redstone 240Z Wash Manual

Fixture Linking (Master/Slave Mode)

1. Connect the (male) 3-pin connector side of the DMX cable to the output (female)
3-pin connector of the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female)
3-pin connector to the input connector of the next fixture consisting of a (male) 3-pin
connector. Then, proceed to connect from the output as stated above to the input of
the following fixture and so on.

Clamp Mounting

This fixture provides a mounting bracket assembly that secures the bottom of the base, the
"Omega Brackets," and the safety cable rigging point together. When mounting this fixture
to truss, be sure to secure an appropriately rated clamp to the omega bracket using an
M10 screw fitted through the center hole of the "omega bracket".
1
1.) Clamp
2.) Omega Bracket
3.) Safety Cable
4.) ¼ Turn Quick Locks

Securing the Fixture

Regardless of the rigging option you choose for your fixtures always be sure to secure
your fixture with a safety cable. Be sure to only use the designated rigging point found on
the underside of the base assembly for the safety cable. Never secure a safety cable to a
carrying handle.
Redstone™ 240Z Wash Manual - Rev. A
4
Page 9
3
2
1/4 Turn 1/4 Turn
(c) 2019 Blizzard Lighting, LLC