Table of Contents
Advertisement
DK
Udskiftning af oliemanchetter / olie af tap ning
GB
Replacement of oil sleeves/oil drain
DE
Auswechselung von Ölmanschetten / Ölablaß
FR
Remplacement du collier de serrage d'huile / vidange d'huile
DK
Prop for olieaftapning. Tilspænding: 1,4 Nm.
GB
Plug for oil drain. Tightening: 1.4 Nm.
DE
Pfropfen für Ölablaß. Anziehmoment: 1,4 Nm.
FR
Bouchon pour vidange d'huile. Alimentation automa-
tique: 1,4 Nm.
DK
Trykstempler demonteres/monteres med fi ngrene.
GB
Demount/mount pistons with your hands.
DE
Druckkolben mit den Händen demontieren/montieren.
FR
Démonter / monter les pistons plongeurs avec les
doigts.
DK
Afstandsring for oliemanchetter demonteres med
skrue træk ker.
GB
Demount spacing ring for oil sleeves with screwdriver.
DE
Abstandring für Ölmanschetten mit Schraubenzieher
demontieren.
FR
Démonter l'anneau d'écartement des manchettes
d'huile à l'aide d'un tournevis.
DK
Oliemanchetter demonteres med specialværktøj
Nye oliemanchetter monteres med montagedorn.
GB
Demount oil sleeves with special tool. Mount new oil
sleeves with mounting mandrel.
DE
Ölmanschetten mit Spezialwerkzeug demontieren.
Neue Ölmanschetten mit Montagedorn montieren.
FR
Démonter les manchettes d'huile à l'aide d'outillage
spécialisé. Remonter de nouvelles manchettes à l'aide
d'un mandrin.
31
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the DYNAMIC Standard and is the answer not in the manual?
Questions and answers
The unit does not start
The Alto DYNAMIC Standard unit may not start due to the following reasons:
1. Machine not plugged in – Ensure the machine is properly plugged into a power source.
2. Defective socket – Try using a different socket.
3. Blown fuse – Replace the fuse and turn off other machines that may be overloading the circuit.
4. Defective extension cable – Try running the machine without the extension cable.
5. Low voltage or low temperature – Activate the trigger of the spray handle to check if the machine starts.
If the issue persists after these checks, further troubleshooting or professional service may be required.
This answer is automatically generated
My alto Kew dynamic 7400 keeps stop starting and won’t stay on permanently. I’m not sure if this an issue with the lance or the machine.
The Alto DYNAMIC Standard 7400 could be stopping and starting intermittently due to air in the inlet hose or pump, which causes the machine to pulsate. Letting the machine run can help remove the air. Other possible causes include a blown fuse, incorrect mains voltage, or the thermal sensor being activated.
This answer is automatically generated