Flowserve PMV F5 Series Manual page 13

Potentiometer only (no transmitter function)
1. Make electrical connections to terminals 7,8 and 9. Check that the
potentiometer is connected to connector C on the printed circuit board.
2. Stroke the actuator to check direction of travel indicated by the potentio-
meter. To change direction of travel, swap wires at terminals 7 and 9.
3. Stroke the actuator to the position where the minimum potentiometer
resistance is desired.
4. Adjust the potentiometer output reading to approx. 50 Ohm by
rotating gear wheel 2 with special tool F5-22 or tip of a screw driver
placed in one of the slotted holes.
5. Stroke the actuator to desired
maximum resistance position and
check reading.
6. Repeat steps 3-5 if necessary to
obtain desired resistance change.
7. Set switches or install frontcover.
Technical specifications
General
Conduit entries
Housing material
Surface treatment
Mounting
Fasteners
Terminals
Enclosure
Switches, mechanical
Type
Rating
Approvals
Temp range
Sensors, Namur
Type
Load Current
Voltage range
Hysteresis
Temp range
Potentiometer
Out put
Elements
Power rating at 70°
Linearity
Resolution
Temp range
4-20 mA position transmitter
Power supply
Out put signal
LED indication at 4 mA
LED indication at 20 mA
Resolution
Minimum rotation travel
Maximum rotation travel
Linearity
Hysteresis
Out put current limit
Load impedance
Temp range
Manual F5
2x 1/2 NPT or 2x PG 13,5 (M20)
Die cast aluminum
ED painting
According to VDI/VDE 3845
Stainless steel A2/A4
2
2,5 mm (AVG 14)
IP66, NEMA 4
Mechanical SPDT V3
*6/2,5A 250 VAC *Res/Ind
CSA,UL,VDE
-40°C to 80°C (-4°F to 185°F)
Proximity DIN 19234 NAMUR
≤ 1mA ≥ 3mA
5-25 VDC
0,2%
-20°C to 80°C (-4°F to 185°F)
5kΩ (4kΩ at 90°)
Conductive plastic
1 W
1%
Essentially infinite
-40°C to 80°C (-4°F to 185°F)
9-28 VDC (24VDC recommended)
4-20 mA
±1%
±1%
Infinite
30°
90°
<1% of full scale
<0,5% of full scale
24 mA DC
800 Ω at 24 VDC
-40°C to 80°C (-4°F to 185°F)
Potentiometer
Weight
Standard enclosure
Explosion proof
Switches proximity
Contact rating
Maximum operating time
Breakdown voltage
Contact resistance
Switch type
Mechanical and
electrical life
7
8
9
0.7 kg (lbs 1.5)
2.1 kg (lbs 4.6)
2 W or 2 VA @ 30 VDC/
VAC, 0.1 A
0.5 miliseconds
200VDC
0.2 Ohms
SPDT hermetically sealed
in one unit
>10 million operations
– 1 – 3