Advertisement
Refer to cleaning the grease filter in this chapter.
Refer to cleaning the charcoal filter or replacing the charcoal filter (depends on
filter type).
To reset the alarm:
Touch the
for 3 seconds.
Replacing the lamp
This appliance is supplied with a LED lamp. This part can be replaced by a technician only.
In case of any malfunction refer to "Service" in the "Safety Instructions" chapter.
Troubleshooting
WARNING! Refer to Safety chapters.
What to do if...
Problem
You cannot activate the appli-
ance.
You cannot activate the appli-
ance.
The lamp does not operate.
The appliance does not ab-
sorb enough vapours.
The filter alarm indicator
on.
The filter alarm indicator
flashes.
Possible cause
The appliance is not connec-
ted to a power supply or it is
connected incorrectly.
The fuse is blown.
The lamp is defective.
The motor speed is not ade-
quate to the appearing va-
pours.
The filter alarm is on. The
is
grease filter must be cleaned.
The filter alarm is on. The
charcoal filter must be re-
placed or cleaned.
Remedy
Check if the appliance is cor-
rectly connected to the elec-
trical supply.
Make sure that the fuse is the
cause of the malfunction. If
the fuse is blown again and
again, contact a qualified
electrician.
Replace the lamp. Refer to
the "Care and Cleaning"
chapter
Change the speed of the mo-
tor.
Refer to the filter alarm in
care and cleaning chapter.
Refer to the filter alarm in
care and cleaning chapter.
11
Hide quick links:
Advertisement
