Table of Contents
Advertisement
6.
remove the slide bar assembly
preventing any movement between
the slide bar and slide bar supports.
7.
tighten the two slide bar clamping
screws.
note! when tightening the screws
do not over tighten. half a turn
maximum is all that is required.
8.
Install the slide bar assembly onto the
mounting brackets and tighten the
2 x M4 screws
9.
Install the end cap.
Soap dish Installation
1.
Install the taper block onto the soap
dish.
2.
Install soap dish screw into the taper
block.
3.
Install the soap dish assembly into
the slide bar and tighten the soap
dish screw.
Pass the flexible hose through the
4.
soap dish.
5.
Install the hose onto the showerhead
and the outlet of the shower control
or rac assembly (Make sure
the hose seals are fitted) do not
overtighten.
6.
Place the showerhead onto the clamp
bracket assembly.
Slide Bar
clamping
Screw
M4
Screw
8
Slide Bar
Support
cap
taper Block
Soap Dish
Soap Dish Screw
Advertisement
Table of Contents
