Operation; Switching Power On And Off; Adjusting The Audio Volume Level And Squelch Setting; Selecting The Operating Band - Yaesu FT-65R/E Operating Manual

O
peratiOn
 Be sure the Battery Pack is installed, and that the
battery is fully charged. Connect the antenna to
the top panel Antenna jack.
 Rotate the top panel's PWR/VOL knob out of the
click-stop to turn on the radio. The current DC
supply voltage will be indicated on the display for
2 seconds. After this 2 second interval, the dis-
play will resume its normal indication of the oper-
ating frequency.
 To turn the radio off, turn the PWR/VOL knob fully counter-clockwise into the
click stop position.
a
djusting the
 You may rotate The PWR/VOL knob to adjust
the receiver level for a comfortable listing level,
using the background noise as a reference.
 To set the squelch level, press F/W key and then
press MONI/T.CALL Switch to open the SQ
LEVEL mode.
Press the [  ] or [ ] key to select the level which
the background noise is muted.
Press PTT switch to save the squelch setting
and back to the normal operation.
 Press the [ #BAND ] key repetitively. This key tog-
gles frequency control between 144 MHz Band
and 430 MHz Band each time you press the
[ #BAND ] key.
 Once you have selected the desired band, you
may initiate manual tuning (or scanning) per the
discussion in the next chapter.
USA model
EU model
EXP model
6
s p
witChing Ower
a v
udiO OluMe
s
eleCting the
Frequency Range
RX
136-174 MHz 144-148 MHz
136-174 MHz 144-146 MHz
136-174 MHz 136-174 MHz
FCC ID: K6620665X20 / IC: 511B-20665X20
O O
n and
l s
evel and
O b
perating and
TX RX
400-480 MHz
400-480 MHz
400-480 MHz
FT-65R/E Operating Manual
Application for FCC / IC
FF
s
quelCh etting
TX
430-450 MHz
430-440 MHz
400-470 MHz