Important Safety Warnings - Dynamix ITM Series Installation, Operation & Maintenance Manual

Important Safety Warnings

Please Read These Warnings Carefully Before Unpacking the Mixer
WARNING!
1. Do not connect to air or electric motor to power source until this Installation operation manual is followed and
the mixer is properly assembled and installed as per design
2. Each mixer is selected for a specific application. Do not use this mixer in applications other than it was
designed and quoted for. Applying a mixer in applications outside of intended use may result in
overload conditions, which will damage the mixer. If you are unsure of the appropriate application please
contact our staff with the relevant mixer serial number.
3. Your mixer has been tested and checked for shaft straightness before shipping. Care must be taken
while handling the shaft to ensure proper operation.
4. It is the operators responsibility to ensure this equipment complies with all local, state / provincial and national
fire electrical and safety regulations
5. Do not operate the mixer in a manner other than the mixers intended application
6. This mixer is intended for professional use only
7. Do not alter or modify this mixer
8. Do not uninstall or service this mixer until you have followed your "Control of Hazardous Energy Sources"
procedure as per OSHA Guidelines, and or the Canadian Occupational Health and Safety Regulations
9. Follow ALL instructions and warnings set out in this manual
10. Ensure mixer is properly grounded
11. If the mixer features a detachable coupling, ensure that the coupling is fully engaged and seated in the fully
rotated position of the coupling lock (rotated 10 degrees)
12. Ensure all equipment and personnel are clear of all rotating parts
13. If your mixer requires lifting by eyebolt or by another method, you must ensure that eyebolts or other means
are securely fastened before lifting the mixer.
14. Do not touch rotating mixer parts
15. Some electric motors will run excessively hot under continued load. Always use lifting handles to lift modular
drive segments off their coupling
16. Check equipment daily. Repair and replace damaged parts immediately.
17. Do not exceed the working air pressure of 100 psi for air motors.
WARNING!
R16 122016
The following safety instructions must be COMPLETELY REVIEWED
AND FOLLOWED before operating any Dynamix Mixer. FAILURE TO
FOLLOW THESE INSTRUCTIONS COULD RESULT IN SERIOUS INJURY
Improper grounding, poor ventilation, open flames, or sparks can cause a
hazardous condition and result in a fire or explosion and serious injury.
FIRE AND EXPLOSION HAZARD
2