Rackmount Wiring Installation - Avaya 9130 EBM Operator's Manual

13. Optional. Insert a rear stop bracket through the inside of each rail
14. Continue to the following section, "Rackmount Wiring Installation."
Rear Stop Bracket

Rackmount Wiring Installation

To install the EBM:
1.
NOTE A ribbon cable connects the LCD control panel to the UPS. Do not pull on the cable
or disconnect it.
Avaya 9130 EBM Site Preparation, Installation and Operator's Manual
behind the EBM. Rotate each bracket and slide the bracket until it
fits tightly against the EBM's rear panel. Secure each bracket to the
×
EBM with one M3 8 pan-head screw. See Figure 5.
Repeat for any additional EBMs.
Figure 5. Securing the Back of the Cabinet (Optional)
Remove the UPS right front cover (behind the LCD control panel).
See Figure 6.
To remove the cover, remove and retain the two screws on the
right side of the cover. Grasp the top and bottom of the cover and
slide the cover to the right.
INSTALLATION
×
M3 8 Pan-Head Screw
S
164201770 Rev 1
21