Denon AVR-X6200W Service Manual page 73

2-6. Remote ID Setup Mode
2-6.1. Actions
This function allows only the desired AV receiver to be operated if multiple DENON AV receivers are used in the same
room.
2-6.2. Starting up
While holding down buttons "STATUS" and "ZONE3 SOURCE" simultaneously, press the power button to turn on the
power.
Select the "6. REMOTE ID" using the "CURSOR f / d " button, then press the "ENTER" button to confirm.
2-6.3. Operations
(1) When Remote ID Setup mode is activated, the following message is displayed.
L1
FLD
L2
(2) Press the "QUICK SECT1-4" button that corresponds to the number you want to this unit.
Button
QUICK SELECT 1
QUICK SELECT 2
QUICK SELECT 3
QUICK SELECT 4
(3) Press the power button to turn off the power.
(4) Press the power button to turn on the power.
Only "QUICK SELECT 1 - 4" and the POWER button on the unit can be used in Remote ID Setup Mode.
b
2-6.4. Setting the Remote control unit
(1) Press and hold the "DEVICE MENU" button for at least 3 seconds until the "DEV.", "TU" and "AVR" indicators flash.
(2) Press "MAIN" button.
The "DEV.", "TU" and "AVR" indicators flash twice.
(3) Press the "1", "2", "3" or "4" button.
The "DEV.", "TU" and "AVR" indicators flash twice.
NOTE:
If the ID of the unit and remote control do not match, "AVAMP z " appears on the display of the unit when the remote
control is used
( z : own remote control ID).
R E M O T E
L2
R E M O T E
L2
R E M O T E
L2
R E M O T E
L2
R E M O T E
I D ?
Display
I D 1
I D 2
I D 3
I D 4
73