Local Ipv6 Network - D-Link DSL-2877AL User Manual

D-Link DSL-2877AL Modem Router User Manual
To access the Local IPv6 Network page, click on the Setup menu link at the top, and then click on the Local IPv6 Network menu link on the left.
On this page we can configure the Local IPv6 Network settings of this product.
IPv6 Address: The address through which PCs access the gateway.
Enable RADVD: Choose to enable or disable router advertisement (RADVD)
service.
Enable DHCPv6 Server: Choose to enable or disable DHCPv6 service.
LAN address config mode: Set the mode address obtaining mode of LAN PCs.
You may choose Stateless or Statefull.
Stateless: a host uses the IPv6 prefix (the subnet address) advertised by a

router and interface ID maked by the MAC address to generate an IPv6 address.
Stateful: IP address assignment through a DHCPv6 server.In the mode,you

need config Start/End Interface ID,DHCPv6 Lease Time,DHCPv6 valid time.
Start/End Interface ID: The address pool using DHCPv6 for address assignment
under statefull mode.
DHCPv6 Lease Time: The address lease time using DHCPv6 for address
assignment under statefull mode.
DHCPv6 Valid Time: The address valid lifetime using DHCPv6 for address
assignment under statefull mode.
Get prefix from WAN: Use the site prefix obtained at the WAN side as the prefix to
issue.
Manual: Manually add a site prefix.

Local IPv6 Network

Page 31