Oximeter Operation; Turning On The Oximeter; Measurement State; Measurement Modes - Henry Schein HS-Vet Instructions For Use Manual

3 Oximeter Operation

3.1 Turning on the Oximeter

The oximeter is turned on by pressing the on/off button, and it will
cycle through a POST before displaying valid data values. Verify
that all the circuitry and functions of the oximeter work properly
during the POST. It needs a few seconds to complete the
verification procedure POST. If it functions incorrectly, do not use
the oximeter.
Press the On/Off button for one second to turn on the oximeter.

If the POST is successfully finished, the oximeter sounds a
tone and enters the main interface.
If there is an error during the POST, the following error codes will
display on the screen:
Error code
Error 01
Error 02
Error 03

3.2 Measurement State

3.2.1 Measurement Modes

There are two measurement modes which are waveform mode and
large numeric mode. By default, the configuration is waveform
mode.
Waveform Mode
In the normal measurement state, oximeter can measure arterial
oxygen saturation and pulse rate, display oxygen saturation level
and symbol (%SpO
display pulse bar graph and Plethysmogram.
Indication
Indicates error for low battery
Indicates error for SpO
Indicates error for main control board
) and PR on interface. Besides, it can also
2
26
board
2