Advertisement
C o n n e c t i n g t o A C p o w e r
1.
Check to make sure the fixture's operating voltage and frequency,
listed on the serial number label on the rear panel, match the AC
voltage and frequency.
2.
Plug the power cable into the socket on the back of the fixture and
an AC outlet.
1RWH $OWKRXJK WKH 6WDUIODVK ,,, FDQQRW EH GLPPHG LW PD\ EH VZLWFKHG RQ DQG RII
UHPRWHO\ XVLQJ VZLWFK SDFNV RU WKH IXOO RQ DQG IXOO RII OHYHOV RQ GLPPHU SDFNV
I n s t a l l i n g t h e m o u n t i n g b r a c k e t
1.
Align the holes in the mounting bracket with the holes in the sides of
the Starflash III.
2.
Place the spacers between the case and the bracket and insert a
knob in each side.
3.
Tilt the Starflash III in the desired direction.
4.
Tighten the thumbscrews.
O p e r a t i n g m o d e s
To operate the 6WDUIODVK ,,,, apply power and set the mode switch on the rear panel to
the "lamp on" or "flash" position.
/ DP S 2 Q
In "lamp on" mode, the lamp stays on; rotation is sound activated and changes occa-
sionally. If there is no sound, reflector rotation stops after 5 seconds.
) ODVK
In "flash" mode, both the lamp and rotation are sound activated. If there is no sound,
the lamp turns off after 5 seconds. There is no difference between the 2 "flash" posi-
tions.
I M P O R T A N T !
Do not attempt to dim the Starflash III :
damage may occur to the electronic components.
user manual
5
Advertisement
