Hach 9525sc User Manual page 18

Menu option
Aut1
idS1
6.1.3 Configure the setup mode
Push to scroll through the options on the Setup menu. Anywhere in the Setup menu, push and
hold for two seconds to go back to the default display. For a description of the Setup menu
options, refer to Table
To navigate the Setup menu, follow these steps:
1. Push and hold
2. Push to select a menu.
3. Push and hold
Menu option
oPEr
Ain
i.Er
i.CA
18 English
Table 3 Operations menu options (continued)
Name
Autotune
Idle set point
4.
or to show the Setup menu.
for two seconds to go back to the default display.
Table 4 Setup menu options
Name Description
Operations Navigates to the operations menu.
Analog input value Shows the process value.
Input error latching Sets error latching to on or off. If latching is on, the user must
manually clear the errors.
Calibration offset Offsets the input indication to adjust for lead wire resistance or
other factors that cause the input indication to change from the
actual process value.
Description
Shows the current status of
Autotune: No or Yes.
Configures a set point that can be
triggered by an event state.