Table of Contents
Advertisement
Code
Refers to
P131
Pad sensor 1
P231
Pad sensor 2
P331
Pad sensor 3
P431
Pad sensor 4
P531
Pad sensor 5
P631
Pad sensor 6
P731
Pad sensor 7
*E-33
Cavity sensor
*E-50
Analog to Digital
Converter Error
E-60
Real Time Clock
Checksum Error
(Blanket warmers only)
*E-61
Real Time Clock
(Blanket warmers only)
E-62
Real Time Clock
(Blanket warmers only)
*E-70
Pad Count Error
*E-71
Personality Error
E-80
EEPROM Error
*E-81
Calibration not
locked
*E-83
EEPROM Error
C om bi n a t i on B l a n ket / F lu i d W a r mer
Action required
Heater pad over-temp error.
◾Software disengages heating pads.
◾Acknowledge error by pressing the ON/OFF button.
◾Allow the warmer to cool.
◾Contact service if the error persists.
◾Sensor reading is above maximum allowable temperature set-point and
over temp value. Blanket warmers trigger at 82°C (180°F). Fluid warmers
trigger at 71°C (160°F).
◾Contact service if error persists.
◾Remove inventory, discard if necessary, and allow the warmer to cool
down.
◾If error persists after cool down and reset, the control assembly should
be replaced by a qualified service technician. Contact service.
Real time clock rechargeable battery backup has discharged.
◾Plug the warmer into the outlet for 30 minutes.
Real time clock not responding. Contact service if error persists.
Timer overlay is present, but no real time clock is detected. Contact service.
More heater pads detected than set for. Hold the ON/OFF button for 12
seconds until display shows "PAd#" (# = number of pads selected [3-7]).
Press up or down arrow to adjust to correct number of pads. [Blanket
warmers: 1.5ft
Fluid warmers: 2.5ft
Contact service.
EEPROM not responding. Contact service if error persists.
Contact service.
Contact service for help resetting the control.
Ope ra tor's Ma nu a l
MN-39 930
▪
▪
3
3
3
, 2.5ft
= 3 pads, 3.5ft
, 4.0ft
3
3
& 4.0ft
= 3 pads].
Re v 1
3/19
▪
▪
T
ROUBLESHOOTING
3
3
, 7.5ft
= 4 pads.
39
Advertisement
Table of Contents
