Table of Contents
Advertisement
Result
Viewing the
temperature data
C om bi n a t i on B l a n ket / F lu i d W a r mer
Continued from previous page
2.
Plug
the USB drive into the port
data.
NOTICE
The warmer goes through the download process:
The LED screen located above the USB port flashes for a few seconds to
▪
show a data transfer is in progress.
The LED screen stops flashing.
▪
The download is complete.
▪
3.
Remove
the USB drive from the port.
4.
Close
the blanket warmer door.
The data has now been downloaded.
To view the temperature data, do the following.
5.
Plug
the USB drive into a computer.
6.
Double-click
on the file.
NOTE:
datalog_MMDDYY_HHMMSS.csv.
7.
Sort
the data as necessary.
Temperature data will be recorded in the same temperature units that are
displayed on the LED screen.
NOTE:
use by service technicians only.
Ope ra tor's Ma nu a l
MN-39 930
▪
▪
. The warmer downloads the temperature
a
Do not remove the USB drive during the download
process.
a
Data is stored on the USB drive in a file named,
Errors recorded by the warmer are intended for
Re v 1
3/19
▪
▪
O
PERATION
EC-TS-005823
Continued on next page
29
Advertisement
Table of Contents
