Sennheiser SK 300 Instruction Manual page 14

Adjusting settings via the operating menu
If you connect the RMS 1 external mute switch, you
can only set the muting via the RMS 1.
The function of the
during this time.
You can set the behavior of the
RMS 1external mute switch via the
item (see next chapter).
For information on how to use the
page 14.
Setting the behavior of the STATUS LED of the RMS 1
external mute switch – "MIC LED"
Advanced Menu
MIC LED
MIC LED
LED On: Unmute
LED On: Unmute
Call up "MIC LED" Select the desired
setting
"Stored"
Via the "MIC LED" menu item, you can set the behavior of
the STATUS LED of the RMS 1external mute switch (optional
accessory) according to the settings of the
menu item and the state of the RF signal.
Settings of the STATUS LED of the RMS 1
MIC LED menu item external mute switch
"LED On: Unmute" The
the transmitter is transmitting an
RF signal or is
"LED On: Mute" The
the transmitter is not transmitting
an RF signal or is muted.
"Disable LED" The
Adjusting the transmission power – "RF Power"
SET
Advanced Menu
RF Power
Standard
RF Power
Standard
Call up Select the desired
"RF Power" setting
"Stored"
Via the "RF Power" menu item, you can adjust the transmis-
sion power in two steps.
It is vital to observe the notes on the supplied
frequency information sheet.
26
MUTE switch is deactivated
STATUS LED of the
"MIC LED" menu
switch ·, refer to
MUTE
MIC LED
LED On: Mute
Store the setting
"Mute Mode"
STATUS LED lights up when
not muted.
STATUS LED lights up when
STATUS LED is off.
RF Power
Low
Store the setting
SET
Adjusting settings via the operating menu
Activating/deactivating the pilot tone transmission –
"Pilot Tone"
SET
Advanced Menu
P i l o t
Name
Pilot Tone A c t i v e
A c t i v e
Call up Select the desired
"Pilot Tone" setting
"Stored"
The bodypack transmitter adds an inaudible signal, known
as the pilot tone, to the transmitted signal. The receiver
detects and evaluates the pilot tone.
The pilot tone supports the receiver's squelch function
(Squelch) and protects against interference due to
RF signals from other devices.
Devices of the ew 300 G1 series (generation 1) do not
support the pilot tone function. Therefore, please observe
the following when combining a bodypack transmitter or
receiver of the ew 300 G3 series (generation 3) with
devices from an earlier evolution wireless generation:
Transmitter Receiver
w G3/ w G2 w G3/ w G2 ... activate the pilot tone
w G3 w G1
w G1 w G3
Adjusting the contrast of the display panel –
"LCD Contrast"
You can adjust the contrast of the display panel in 16 steps.
Resetting the settings made in the operating menu –
"Reset"
SET
Advanced Menu
Reset
Reset Yes
Select the desired
Call up "Reset"
setting; apply the
setting
"Stored"
When resetting the settings made in the operating menu,
only the selected settings for the pilot tone and for the
frequency banks "U1" to "U6" remain unchanged. For an
overview of the factory-preset default settings, refer to the
supplied frequency information sheet.
P i l o t
I n a c t i v e
Store the setting
SET
Make sure to ...
function on both
bodypack transmitter
and receiver.
... deactivate the pilot
tone function on the ew
300 G3 bodypack trans-
mitter.
... deactivate the pilot
tone function on the ew
300 G3 receiver.
27