Step 4: Connecting The Power Cord - Sony DVP-F41MS Marketing Operating Instructions Manual

When you install the player on the wall
Attach the jack cover as in the same way for the horizontal installation.
Fasten screws (not supplied) to the wall at the same height 80 mm apart. The screws should
protrude by 4 to 5 mm.
Remove the seals covering the hanging holes. Hang the player on the screws. Push the player
tightly against the wall.
80 mm
4 - 5 mm
Notes
• Use the screws that matches the wall material and strength.
• Install the player on a vertical and flat wall where reinforcement is applied. Do not install the player if the wall is
not vertical, flat or strong enough.
• Contact a screw shop or installer regarding the wall material or screws to be used.
• After the player has been used for long time on the wall, the wall behind or above the player may discolour or peel
off by radiation of heat from the player depending on the wall material.
• Sony will refrain from any responsibility on the accident or damage caused by improper installation, lack of
durability or the wall or screws, improper operation, natural calamity, etc.

Step 4: Connecting the Power Cord

Plug the player and TV power cords (mains lead) into an AC outlet (mains).
Do not connect the power cord of your player to the "switched" power socket (mains) of an
amplifier (receiver). Otherwise, when you turn off the power of your amplifier (receiver), the
settings for the player may be lost.
4.2 mm
9.2 mm
33