Battery Removal And Disposal; Putting It Away - Bissell Spot Lifter 1715 Series User Manual

When You're Done Continued
Remove the Tank Plug by turning approximately 1/4 turn
5.
counterclockwise and lifting out. Empty Tank.
Fill Collection Tank with clean water. Rinse thoroughly and
6.
discard water. Be sure to rinse nozzle area.
Replace Plug and turn approximately 1/4 turn clockwise,
7.
until snug.
To replace the Tank, engage hinge at bottom and tilt Tank
8.
up to Handle, making sure that the Cleaning Solution con-
nection in the Handle enters the port in the Tank. Depress
the Tank Release Button, and snap the Tank into place. Test
for a secure fit before using.
Check the Solution Tank. If a significant amount of BISSELL
9.
Little Green formula/water remains, you may leave it in the
Solution Tank for your next cleaning task.
Check Spray Nozzle for accumulated dirt or debris. If nec-
10.
essary, clean with soft bristle brush.
Recharge Spot Lifter.
11.

Putting It Away

Clean exterior surfaces of Spot Lifter with a soft cloth
1.
dampened with water only. Do not use a strong detergent
or other cleaners, as this may damage the finish.
Store Spot Lifter in a protected, dry area, at room tempera-
2.
ture (40° - 110°F).

Battery Removal And Disposal

Important: Unplug charger.
1.
Remove tanks (front and rear) and discard.
2.
Remove screws (6) holding Product Housing together
3.
(see diagram).
Use screwdriver to score Rating Label on bottom of unit.
4.
Separate Housings and locate Battery Pack in bottom/ cen-
5.
tre of unit.
5.
FU LL
WARNING:
This product contains a
rechargeable nickelcadmium
battery (sometimes referred
to as a "Ni-Cad" battery)
pack. The average life of a
Ni-Cad battery is 5-7 years,
depending on frequency of
use. According to Federal
regulations, proper
removal and disposal of
Ni-Cad batteries are required.
FUL L